Gcode pause command Pro 2 series

Thoughts about Raise3D, 3D printing and making in general.
Posts: 1
Joined: Tue Apr 23, 2019 9:12 am

Gcode pause command Pro 2 series

Postby nolan » Tue Apr 23, 2019 9:50 am

Hi there, I am trying to create a calibration test program, which will make the left extruder going to 13 points on the bed with 30sec pause between each point. The 30 seconds pausing allow the user to check the calibration with the 0.2mm feeler gauge between the bed and the left extruder. My question is what is the gcode command to pause the printer (Pro 2 / Pro 2 Plus) ?
Many thanks for helping.

Return to “General”

Who is online

Users browsing this forum: No registered users and 1 guest