eSun PLA pro

Thoughts about Raise3D, 3D printing and making in general.
Posts: 110
Joined: Sat Jul 16, 2016 8:20 pm

eSun PLA pro

Postby RiserDog » Thu Dec 15, 2016 8:41 pm

Was wondering if anyone else has tried eSun PLA Pro? I bought a role and have not been able to get it to print without jamming the extruder. Tried several settings and also had take of the guide tube. I have success with just regular eSun pla. :)

User avatar
Posts: 69
Joined: Sat Aug 06, 2016 5:29 am

Re: eSun PLA pro

Postby basilfawlty » Thu Dec 15, 2016 10:23 pm

I have run a lot of eSun ABS Pro (not the same I know) and I also ran into lots of jamming issues until I switched our my extruder gear for this one. I've been running non-stop for a week now with no clogs.

PS: I bought a LOT of rolls so I was very motivated to find a solution. :)
Raise3D N2+

Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests