Polycarbonate - test Print.

Thoughts about Raise3D, 3D printing and making in general.
Rockman
Posts: 70
Joined: Sat Jul 02, 2016 7:53 pm

Polycarbonate - test Print.

Postby Rockman » Wed Nov 30, 2016 8:38 pm

Hi there.

Finally ventured into the Polycarbonate world. I must say the N2 did a great job. Also a Thankyou to MechaMonster for some tips earlier.

Filament
Filaments.ca
Easy PC

Bed temp
100

Nozzle temp
290

Layer
0.2

Nozzle
0.4

Fill density
100

Brim

Print speed all round
40mm/s

Retraction
25mm/s
Retract amount 3mm


Ovrrall I am satisfied and will be using this filament for anything that needs to be durable and tough including heat resistant.

R
Attachments
20161130_152921.jpg
20161130_153000.jpg

User avatar
Vicky@Raise3D
Posts: 6507
Joined: Fri Mar 25, 2016 3:54 am

Re: Polycarbonate - test Print.

Postby Vicky@Raise3D » Thu Dec 01, 2016 11:00 am

Thanks for your sharing supporting! :)

Rockman
Posts: 70
Joined: Sat Jul 02, 2016 7:53 pm

Re: Polycarbonate - test Print.

Postby Rockman » Fri Dec 02, 2016 7:29 pm

Thanks Vicky.

Always good to share settings among Raisers as it helps us all in the long run to try new filaments and really see how great the N2 is :)


Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests