Page 1 of 1

Blurred camera images on Pro2+

Posted: Mon Sep 24, 2018 3:47 pm
by mtvision
The camera of my Pro2+ gives blurry images. I'd like to adjust the lens. Does anyone know how to do that? I did not found any instructions yet.

Re: Blurred camera images on Pro2+

Posted: Tue Sep 25, 2018 2:01 am
by Vicky@Raise3D
You can find your camera located at right front corner above the top cover but facing to print plate.
Once you find it, please check whether the film of the camera has been removed or not. If so, you can manual rotate the bulge lens to adjust focus.

Re: Blurred camera images on Pro2+

Posted: Tue Sep 25, 2018 3:41 pm
by EldRick
It's just a poor camera, not out of focus.