Page 1 of 1

Shoud the extruder wobble like this ?

Posted: Tue Oct 25, 2016 6:38 pm
by Monty
Should it be like this. It's quite loose
[url]
http://tinypic.com/r/2s993c9/9[/url]

Re: Shoud the extruder wobble like this ?

Posted: Tue Oct 25, 2016 7:02 pm
by Trhuster
To me it out off spec. I cheering for Raise3d to get successful but they need to source better bearings and rods to avoid this amount off play in the extruder head.

Re: Shoud the extruder wobble like this ?

Posted: Tue Oct 25, 2016 7:47 pm
by Monty
Yer I was looking to see if there was bearing clamps that where loose. That's exactly what it's like.

Re: Shoud the extruder wobble like this ?

Posted: Wed Oct 26, 2016 10:20 am
by Vicky@Raise3D
Please shoot a ticket about this problem to our support system.

Re: Shoud the extruder wobble like this ?

Posted: Wed Oct 26, 2016 12:09 pm
by Monty
OK Have done

Re: Shoud the extruder wobble like this ?

Posted: Wed Oct 26, 2016 3:36 pm
by sylus
same wobbling for mine (ticket done)

Re: Shoud the extruder wobble like this ?

Posted: Sat Nov 12, 2016 7:06 pm
by jvingaard
Hi,

I just tighten, all the rod screws and that solved the extruder wobble. :-)

Re: Shoud the extruder wobble like this ?

Posted: Mon Nov 14, 2016 5:56 am
by Vicky@Raise3D
Do you mean that you have loose screws which are in below checking list?
X and Y axis check list.pdf
(205.63 KiB) Downloaded 95 times

Re: Shoud the extruder wobble like this ?

Posted: Mon Nov 14, 2016 11:19 am
by Monty
below checking list ?

Re: Shoud the extruder wobble like this ?

Posted: Tue Nov 15, 2016 2:52 am
by Vicky@Raise3D
I want to check with jvingaard whether there on some loose screws on X Y axis would cause extruder wobble.

Re: Shoud the extruder wobble like this ?

Posted: Tue Nov 15, 2016 5:26 pm
by walshlg
I wonder if this looks worse than it really is since the cold end is so very long it magnifies the apparent movement