Page 1 of 1

Buildplate Glass Brake

Posted: Thu Aug 02, 2018 11:15 am
by mark_3d
It's happen to me that after a big print was finished the blass was curved and when i tried to remove the printed part, the glass brake. I usually use dimafix and was printing abs x. It could be tension between the printed part and the glass?

Re: Buildplate Glass Brake

Posted: Thu Aug 23, 2018 10:21 pm
by sperman
I am having the same issue with ABS. I'm wondering if there isn't a better quality glass that won't have this issue.

Re: Buildplate Glass Brake

Posted: Fri Aug 24, 2018 6:47 pm
by DrewPetitclerc