Thoughts about Raise3D, 3D printing and making in general.
3 posts • Page 1 of 1
I'm trying to learn how to print in PETG on my Rasise 3d pro2 using Ideamaker. My latest print has terrible surface finish. The first few top layers have voids above the infill hollow areas, like little volcano's. The bed temperature is 60c. The filament is fresh and dry. The nozzle temperature is 255c. I have the fans running at 35%. Infill is a 15% grid pattern. Any suggestions what to adjust in the slicer? Enclosed is a picture after about 12 hours of printing (pic1). The second picture is after 2 more layers applied (pic2).
The issue we are seeing here is called Pillowing which is caused when the solid fill layer does not have enough support underneath it from the infill and drops in and when it cools will curl up like what we are seeing. To fix this I recommend either increasing the infill or adding more top solid fill layers.
Who is online
Users browsing this forum: No registered users and 1 guest