Problems with First Layers

Thoughts about Raise3D, 3D printing and making in general.
alermendez
Posts: 1
Joined: Tue Sep 14, 2021 5:11 pm

Problems with First Layers

Postby alermendez » Tue Sep 14, 2021 7:41 pm

Hi All,

Hope you guys are fine.
Currently where I'm working we have a Raise3D Pro2 Plus and it prints awesome but we have the problem that in the first layer is too close to the nozzle and it's causing an irregular surface. I'll attach a photo where you can see this. I'm very new to this machine so any help is appreciated. Thanks.
Raise3d 1st layer.jpeg

User avatar
Steven@Raise3D
Posts: 477
Joined: Thu Dec 17, 2020 11:24 pm

Re: Problems with First Layers

Postby Steven@Raise3D » Wed Sep 15, 2021 12:24 am

alermendez wrote:Hi All,

Hope you guys are fine.
Currently where I'm working we have a Raise3D Pro2 Plus and it prints awesome but we have the problem that in the first layer is too close to the nozzle and it's causing an irregular surface. I'll attach a photo where you can see this. I'm very new to this machine so any help is appreciated. Thanks.
Raise3d 1st layer.jpeg


Please follow this guide to set the Z-offset properly: https://www.youtube.com/watch?v=WPNr4GzwX9o


Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests