Printing Same Gcode through RaiseCloud Slower?

[Trenth]

Hello,

I've created some gcode in IdeaMaker and uploaded them to RaiseCloud, but the print speed is significantly slower than the direct file. It's almost as if the entire print is in slow-mo. If I had to guess, the speeds are perhaps 40-50% slower.

IdeaMaker says a print should take 18 minutes, but the Cloud file takes 39 for it. Another one said 2 hours in the slicer and it took 2 hours and 40 minutes through RaiseCloud. Normally, the IdeaMaker estimated times are pretty close, but I don't understand why it's so far off.

Is there some setting in RaiseCloud that changes the units/speed/extrusion?

[Vicky@Raise3D]

The estimate print time for 3rd party printers are all calcualted according to OCTOPrint's source program, so time is just an estimate.