filament starts and then stops extruding.

Trevor13
Posts: 7
Joined: Tue Jun 01, 2021 4:44 am

filament starts and then stops extruding.

Postby Trevor13 » Tue Jun 01, 2021 5:07 am

I have another printer Pro2 Plus that I clean the head make sure there is no blockages.
Extrude the filament seems fine.
Check the height of the nozzle to the bed. that is fine.
Start a print with a raft.
it does the outside line of the print but when it goes to do the internal part of the raft it runs out.
I go to extract the filament but it is caught in the head and snaps.
I pull apart the head clean it out and start the same thing all over again.

User avatar
Steven@Raise3D
Posts: 415
Joined: Thu Dec 17, 2020 11:24 pm

Re: filament starts and then stops extruding.

Postby Steven@Raise3D » Fri Jun 04, 2021 1:28 am

Trevor13 wrote:I have another printer Pro2 Plus that I clean the head make sure there is no blockages.
Extrude the filament seems fine.
Check the height of the nozzle to the bed. that is fine.
Start a print with a raft.
it does the outside line of the print but when it goes to do the internal part of the raft it runs out.
I go to extract the filament but it is caught in the head and snaps.
I pull apart the head clean it out and start the same thing all over again.


Can you please confirm that your front fan is functioning at 100% at all times as soon as the machine is powered on?

Trevor13
Posts: 7
Joined: Tue Jun 01, 2021 4:44 am

Re: filament starts and then stops extruding.

Postby Trevor13 » Tue Jun 08, 2021 5:07 am

Thank you for replying Steven I can't confirm at this time as we are in the process of moving the printers are switched off ready for the move. I will be able check in about two weeks.

User avatar
Steven@Raise3D
Posts: 415
Joined: Thu Dec 17, 2020 11:24 pm

Re: filament starts and then stops extruding.

Postby Steven@Raise3D » Sat Jun 12, 2021 1:27 am

Trevor13 wrote:Thank you for replying Steven I can't confirm at this time as we are in the process of moving the printers are switched off ready for the move. I will be able check in about two weeks.


No problem. If you could please also attach a few images of the printhead and cooling fans.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 3 guests