Page 1 of 1

5 Watt Pump on Extruder Connection Board?

Posted: Sun May 09, 2021 11:27 am
by Transzendent
As I also want to switch to watercooling, could I connect a 5 Watt 12V DC waterpump directly to one of the white plugs on the Extruder Connection Board or is this to much for the electronics?
Any ideas :?:

Re: 5 Watt Pump on Extruder Connection Board?

Posted: Fri May 14, 2021 11:00 am
by Transzendent
I just tried the connection of the front cooling fan, it worked for a minute without damaging the board. As I have all parts, I will go for a longer run. I will report here in about one ore two weeks.

Re: 5 Watt Pump on Extruder Connection Board?

Posted: Wed May 26, 2021 2:41 pm
by Transzendent
20210526_163602.jpg


First print, seems to work. Flow is enough with 3.5mm inside diameter of the coolers. If something gets damaged I will post here again, for now I am happy.