5 Watt Pump on Extruder Connection Board?

Transzendent
Posts: 3
Joined: Sun May 09, 2021 11:19 am

5 Watt Pump on Extruder Connection Board?

Postby Transzendent » Sun May 09, 2021 11:27 am

As I also want to switch to watercooling, could I connect a 5 Watt 12V DC waterpump directly to one of the white plugs on the Extruder Connection Board or is this to much for the electronics?
Any ideas :?:

Transzendent
Posts: 3
Joined: Sun May 09, 2021 11:19 am

Re: 5 Watt Pump on Extruder Connection Board?

Postby Transzendent » Fri May 14, 2021 11:00 am

I just tried the connection of the front cooling fan, it worked for a minute without damaging the board. As I have all parts, I will go for a longer run. I will report here in about one ore two weeks.

Transzendent
Posts: 3
Joined: Sun May 09, 2021 11:19 am

Re: 5 Watt Pump on Extruder Connection Board?

Postby Transzendent » Wed May 26, 2021 2:41 pm

20210526_163602.jpg


First print, seems to work. Flow is enough with 3.5mm inside diameter of the coolers. If something gets damaged I will post here again, for now I am happy.


Return to “Pro2 Series”

Who is online

Users browsing this forum: Anown and 2 guests