Pro2 Plus Thordsen 3D Filament Dryer Mounts & Shelf

JPT
Posts: 5
Joined: Tue Sep 08, 2020 11:13 am

Pro2 Plus Thordsen 3D Filament Dryer Mounts & Shelf

Postby JPT » Sat Oct 10, 2020 11:00 pm

My printer is in a humid environment, so I added a Thordsen 3D Remote Filament Dryer to dry the filament during printing.

This mod requires no drilling or other permanent modification or alteration of the printer.

There is no limitation of or intrusion into the working envelope of the printer.


Image

Image

Image

Image


The heaters mount on the spool rails via clamps, so you can set them to any location that you prefer.

You can mount the remote heaters on either rail, so you can retain use of the lower reel locations if desired.

I always print directly from a reel dryer/dispenser, so I used the lower rail for cable management for now.


Image

Image

Image


You can route the power cables for the heaters through the printer's cable duct and out the back or down to the printer cart.

Image


Hardware:

The mount clamp inserts are M3 6mm and the screws are M3 10mm socket head.

The mount saddle inserts are M3 4mm and the screws are M3 8mm socket head.

The shelf clamp inserts are M3 6mm and the screws are M3 10mm socket head.

The shelf attaches to the printer hinge side with M4 8mm button head cap screws.

There is a cutout in the shelf support to provide finger clearance for these screws:

Image


Files:

The step and stl files are here:

https://www.amboymedia.com/cad/raise3d-pro2-plus-tordsen-heater.zip


Heaters:

Thordsen 3D site is here:
https://thordsen3d.com/

I have no affiliation with Thordsen 3D.

Their customer service has been exemplary so far.

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests