Can you change nozzles without removing hotend?

mdana
Posts: 61
Joined: Mon Oct 07, 2019 1:36 am

Can you change nozzles without removing hotend?

Postby mdana » Sun Nov 03, 2019 11:47 pm

Is it possible to change nozzles without removing the entire hotend? If not, has anyone come up with a way to set the offset without going through multiple iterations of the calibration procedure?

User avatar
Vicky@Raise3D
Posts: 5958
Joined: Fri Mar 25, 2016 3:54 am

Re: Can you change nozzles without removing hotend?

Postby Vicky@Raise3D » Mon Nov 04, 2019 7:26 pm

We don't recommend to change nozzle with hotend installed on printer. The throat tube is very fragile. Even you hold the hotend on hand to do nozzle swap, you will need to pay special attention to not apply extra force onto throat tube to not break it. It will be very hard to control when the hotend is installed and throat tube being hold by set screws on printer.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests