I had to remove all of the belts in order to make some repairs to my Pro2.
I used milling machine parallels to set the distance from the extruder head to the stops, and it runs good, I just wondered if there was an official way to adjust the gantry after major repairs. The documentation calls out a ‘gantry calibration’ guide, but I can only find it for the N2.
2 posts • Page 1 of 1
The gantry design for Pro2 series and N series are pretty similar. You can use the guide for N series on Pro2 series to do calibration. If you have any further questions on your printer, feel free to contact our support team.
Who is online
Users browsing this forum: No registered users and 2 guests