Gantry calibration steps needed - Pro2

Simko
Posts: 5
Joined: Thu Oct 24, 2019 12:30 pm

Gantry calibration steps needed - Pro2

Postby Simko » Tue Oct 29, 2019 2:37 am

I had to remove all of the belts in order to make some repairs to my Pro2.

I used milling machine parallels to set the distance from the extruder head to the stops, and it runs good, I just wondered if there was an official way to adjust the gantry after major repairs. The documentation calls out a ‘gantry calibration’ guide, but I can only find it for the N2.

Thanks!

User avatar
Vicky@Raise3D
Posts: 5958
Joined: Fri Mar 25, 2016 3:54 am

Re: Gantry calibration steps needed - Pro2

Postby Vicky@Raise3D » Tue Oct 29, 2019 7:45 pm

The gantry design for Pro2 series and N series are pretty similar. You can use the guide for N series on Pro2 series to do calibration. If you have any further questions on your printer, feel free to contact our support team.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests