Pro2 Cart

Techmonkey77
Posts: 1
Joined: Thu Jul 11, 2019 4:19 pm

Pro2 Cart

Postby Techmonkey77 » Thu Jul 11, 2019 9:03 pm

My company purchased a Pro2 cart along with the printer. While I can figure out what tools/parts go into some of the cut outs, others are leaving me baffled. Is there a picture somewhere as to what part goes where?

User avatar
Spud
Posts: 30
Joined: Wed Nov 21, 2018 5:18 am

Re: Pro2 Cart

Postby Spud » Mon Jul 15, 2019 2:51 pm

I got the cart and wondered the same thing.
Needlenose plier cutouts would have been nice.
Also, my digital calipers are longer than the cutout :(
The only things that fit in the cutouts are the tweezers and the hex wrench set that came with the printer, and a small flashlight.
No cutout for the flat scraper that comes with the printer.
But there is a cutout for what could be a large swiss army knife (with nail clippers, corkscrew, scissors and spoon).

I do like the roll-up door where all of the filament goes.
But know that the drawer, sides and roller door are all nonmetal components.
I love the table but when I saw that not much was made from metal I was initially pissed due to the crazy cost.
But I'm glad I have it.
California, USA
R3D Pro2


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests