Temperature raising as soon as machine turns on

Hussain
Posts: 6
Joined: Thu May 09, 2019 5:35 am

Temperature raising as soon as machine turns on

Postby Hussain » Tue Jul 09, 2019 9:46 am

Hi,

Its been a few months of getting 2 Raise3d pro2's , both had a major clog as soon as I got it, recently while trying to remove the clog I heated the nozzles to soften the plastic around the extruder. While removing the plastic the left heater wire had shorted, the exact same thing happened on the other machine. I changed the fuse on one machine and started and it works fine for now. On the other machine the left extruder heats up to 330 C as soon as I put on the machine, I read somewhere that its due to a burnt mosfet. Could someone guide as to how to get it working as soon as possible

Regards,
Hussain.

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest