Exhaust Fan and duct

devmailboxlive
Posts: 19
Joined: Fri Jun 07, 2019 11:06 pm

Exhaust Fan and duct

Postby devmailboxlive » Sun Jul 07, 2019 5:01 pm

I'm thinking of attaching additional exhaust fan, and a duct to my Pro2 Plus. Has anybody here done something similar?
If you've done something like that, could you share what you did, and which parts you used?

If I understood correctly, HEPA filter is not enough for the particles that could be emitted. My printer is currently standing in a relatively small office room, and I'd like to make sure my setup is safe enough.

Thank you.

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest