Page 1 of 1

Throat tube glued to hot end?

Posted: Mon May 20, 2019 2:57 pm
by Sunshine
I recieved a new hot end and the throat tube is glued with something to the hot end. The ones that came with the printer did not have any glue, is this something that is new?

IMG_0611.jpg

Re: Throat tube glued to hot end?

Posted: Mon May 20, 2019 6:30 pm
by detroitus
Are you sure that's not just thermal paste?

Re: Throat tube glued to hot end?

Posted: Mon May 20, 2019 10:37 pm
by Vicky@Raise3D
It is for holding the position of throat tube and seal to avoid damage during transportation. But won't affect disassembling.
We always add a little since later batches of V2 hotend on N series. Not a newly added feature.