Preparing to swap nozzle - Any last minute advice?

User avatar
red
Posts: 98
Joined: Tue Jan 22, 2019 7:57 pm

Re: Preparing to swap nozzle - Any last minute advice?

Postby red » Fri Dec 27, 2019 2:42 am

Vicky@Raise3D wrote:Do you mean that due to one of the nozzles has bigger diameter, you want to move it to higher than the default 0.2mm height instead?


That is correct. I am hoping to use the 1.0mm nozzle for fast rough prints.

User avatar
Vicky@Raise3D
Posts: 6507
Joined: Fri Mar 25, 2016 3:54 am

Re: Preparing to swap nozzle - Any last minute advice?

Postby Vicky@Raise3D » Fri Dec 27, 2019 9:08 pm

I believe you can set different global offset based on model printed by different nozzles in ideaMaker.
You will still need to go through the nozzle calibration guides unless you want to put nozzles in different physical height then you may need different size feeler gauges to measure the actual height.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests