Slow Heating Bed

batab
Posts: 10
Joined: Fri Mar 22, 2019 8:16 am

Slow Heating Bed

Postby batab » Tue Apr 02, 2019 9:53 am

Hello,

is there a way to speed up the heating ramp of the bed?

While I understand that the bed is big and dissipates a lot through irradiation, conduction and convection, I don't think it is normal nor acceptable that it can take up to 30+ minutes to reach 100-110°C. Especially if we consider that the printer is usually enclosed when operating at such temperature and this lowers heat dissipation of the bed.

Maybe heat the bed only and when the bed is almost at target temperature start heating the extruders so that you can feed more juice to the bed alone? And/Or just feed more juice overall during heating?

Best Regards,
Davide

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest