I just tried a new roll of Amazon Basics black PLA and it jammed up my Pro2, twice. I would print 3 or 4 layers and then stop extruding. Each time when I went to remove the filament it would retract but I couldn't pull it out the rest of the way. I had to remove the filament out sensor and cut of the end to get it out. Well the first time I pulled it harder but a piece broke off so I had to take it apart then.
I don't know if it has feeding problems because of it's rough texture or what.
Anybody else have luck with this?
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest