Bad Fan?

Posts: 12
Joined: Fri Jan 11, 2019 12:43 pm

Bad Fan?

Postby PTXer » Fri Feb 08, 2019 6:00 pm

First post here, and very new to 3D printing. I've only had my Pro2 less than a month and the left extruder fan is already making noise when it first starts up (for about 15 seconds). How long should these fans last? It hasn't been in use 24/7, but I have done a few 48hr pieces. Thanks for any info. By the way, have learned a lot so far from all the issues discussed on this forum.


User avatar
Posts: 5061
Joined: Fri Mar 25, 2016 3:54 am

Re: Bad Fan?

Postby Vicky@Raise3D » Fri Feb 08, 2019 7:28 pm

If the fan doesn't work from the very beginning, you can contact our tech support to claim a new part.
Usually the fan is considered as a consumable part, as due to improper use, users sometime will have filament or tools stuck into fan cause damage or filament oozing or warp from hotend or printed model, will also do harm to fan. But if just leave the fan working under normal operation, it should can last for a few months.

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest