Overhiting

PR0GRAMM1ST
Posts: 1
Joined: Fri Jan 18, 2019 2:08 pm

Overhiting

Postby PR0GRAMM1ST » Fri Jan 18, 2019 3:31 pm

When I try to download a filament, the temperature on both extruders has dropped to 4 degrees. It turned out that the fuse has been burned down by 10 amperes. After being replaced, the left extruder automatically started to warm up to 330 degrees without any command.

User avatar
Vicky@Raise3D
Posts: 5061
Joined: Fri Mar 25, 2016 3:54 am

Re: Overhiting

Postby Vicky@Raise3D » Sat Jan 19, 2019 12:34 am

Please reach to our technicians at http://help.raise3d.com. Please do not use your printer until the issue has been confirmed.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests