problem with bed leveling and z axis height adjustment

froth
Posts: 10
Joined: Wed Aug 15, 2018 5:18 pm

problem with bed leveling and z axis height adjustment

Postby froth » Sun Dec 23, 2018 4:14 pm

Hi,
my plate is bad leveled.
The problem is that the middle part of the table is higher then sides ( the midline parallel to Y axis is higher). I tried to level the plate. However, the nylon screw are even not touching the plate so by rotating them I can lower the bed! One would say try to raise sides instead. Yes, I could do it, but my plate is in the lowest possible position according to Z axis. I can't lower the bed as well! So I stuck.
I tried to raise the nozzle. I did it a little bit, but still it is not enough. I don't know if there is any other method to raise the nozzle more?
Any other ideas?

Shelton
Posts: 375
Joined: Thu Jul 12, 2018 8:34 pm

Re: problem with bed leveling and z axis height adjustment

Postby Shelton » Mon Dec 24, 2018 10:01 pm

Try to adjust corners first... use digital gauge for it. It will be easier.

froth
Posts: 10
Joined: Wed Aug 15, 2018 5:18 pm

Re: problem with bed leveling and z axis height adjustment

Postby froth » Tue Dec 25, 2018 8:46 pm

do you have stl for digital gauge holder?

Shelton
Posts: 375
Joined: Thu Jul 12, 2018 8:34 pm

Re: problem with bed leveling and z axis height adjustment

Postby Shelton » Tue Dec 25, 2018 8:49 pm

You can find it here on the forum and on https://www.thingiverse.com also.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest