Cables touching Belts

Posts: 33
Joined: Mon Sep 03, 2018 2:02 pm

Cables touching Belts

Postby SchMax » Fri Nov 30, 2018 10:39 am


When i print large prints (30x30cm) cables from the extruder touch the belts on the right side!
do other people have this problem too or is this just faulty cable management with my printer?

I already solved the Problem by tighten them to the extruder-head with cable ties.
Maybe you can take this Problem into consideration for the future.

Inked2018-11-30 11.26.24_LI.jpg
Raise3D Pro2
Flashforge Finder

3D Printing of Architecture Models

Posts: 32
Joined: Sat Sep 08, 2018 10:02 pm

Re: Cables touching Belts

Postby walleywalker » Fri Nov 30, 2018 6:37 pm

I noticed this on mine as well while printing large area prints. I did the same as you and just managed to push them all up and tuck them away a bit. It did fray the protective sheathing on the heating element wires a bit before I noticed it. Definitely something to look out for from end-users and Raised3D production lines alike.

Posts: 406
Joined: Thu Jul 12, 2018 8:34 pm

Re: Cables touching Belts

Postby Shelton » Fri Nov 30, 2018 8:15 pm

Mine the same. Also, some weird noises when I will print large XY objects on edge positions... build quality...

Posts: 9
Joined: Mon Nov 26, 2018 3:07 pm

Re: Cables touching Belts

Postby Zoidsfan77 » Mon Jan 07, 2019 8:31 pm

My printer does this also, reducing advertised build volume by about 5mm on the X.
I will probably tie these out of the way, as you have done.
I have notice the cable management on my Pro2+ is quite subpar.

Posts: 406
Joined: Thu Jul 12, 2018 8:34 pm

Re: Cables touching Belts

Postby Shelton » Tue Jan 08, 2019 7:35 am

Mine also. Rear part.

User avatar
Posts: 479
Joined: Sat Nov 26, 2016 12:54 am
Location: Borås, Sweden

Re: Cables touching Belts

Postby Noren » Tue Jan 08, 2019 10:07 am

The same on my N1.

Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests