Shelton wrote:E3printable please check last setup about cooling angle... I'm not sure that is too high right now and air flow is a lttile bit higher than surface... but it could be subjective feeling.
I have tested this with some small details in PLA with lid on, and it works
I was made the double check. Is better on old setup with PETG. No surface bulbs. With 2 degrees more air flow is above of surface of the material. In some situation will be good enough with some not. I was print again the same components with old spacers. And the surface is better. One millimeter and we have big difference
Shelton wrote:Ok research done. Black filament was wet... so everything works perfect.
Sweet! Then I trust you on that, and can start really enjoying my printer 100%
The print quality is second to none if you ask me, and I have tested A LOT of printers... Now that it can take big and small projects in all materials with stride, I'm a happy camper here
In my opinion, the machine needs some hardware improvements like full detachable printer head like Ultimaker. Just fast modules. And some software polishing. And it could be a nice champion in that price range, isn't it?
Well, my opinion on that is that I love the fact that I can change the nozzle a lot cheaper than changing the whole hotend aka BCN/UM. I like the simplicity of that. And yes, software needs some polishing. Like the ability to monitor the printer via app/website.
Who is online
Users browsing this forum: No registered users and 2 guests