Nozzle lifting system on Raise3D N2

ig230mb
Posts: 2
Joined: Sat Jul 10, 2021 1:43 pm

Nozzle lifting system on Raise3D N2

Postby ig230mb » Sat Jul 10, 2021 2:20 pm

Hello everyone,

I am just thinking of mounting a nozzle lifting system taken from Raise3D Pro2 (including hotends and all Fans) on a Raise3D N2 printer.
The question is if it's possible to somehow connect the controller board of that nozzle lifting system to a Raise3D N2 motion control board? I am currently using 1.1.9 firmware from ABH10. Will that firmware support nozzle lifting or some adjustment and recompiling is needed?
Thanks for any advices/hints here

Return to “N Series”

Who is online

Users browsing this forum: No registered users and 2 guests