I was wondering if anyone has more information on a replacement for the heated bed for a N2 Plus dual extruder setup. I recently purchased one and the connectors look like they need to be replaced but upon further inspection, the connector was no longer attached to the heated bed. I thought about maybe being able to solder back a new set of connectors but I realized that a piece of the board came of (see image). I looked on the Raise3D website but found no spare parts and I haven't fount spare parts anywhere else. I have submitted a ticket and I am waiting for a reply but I figure I would ask the community if there was another alternative. Thank you in advance.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests