V2 hotend difficult to disassemble?

Daws
Posts: 43
Joined: Wed Dec 13, 2017 6:41 am
Location: Qld, Australia

V2 hotend difficult to disassemble?

Postby Daws » Mon Jun 29, 2020 1:11 am

Long story short...

I bought a complete new V2 hot end from my local reseller, before I installed it I took it apart to put some hi-temp copper grease on the threads (throat-tube, tiny screws), good practice to make it easier to pull apart for maintenance in the future.

I found that the throat tube was very difficult to remove from the heater block, this was a brand-new, unused unit (Yes, I removed the locking screw). I believe that the threads on the throat tube have been damaged by the locking screw, or the locking screw cross-drilling has not been adequately deburred, causing the thread to bind slightly. This would have been obvious to the person that assembled in in the factory.

Has anyone else noticed that the throat-tube is difficult to remove? The Raise3D V2 hotend assembly video shows the heater block spinning on easily, like it should do, there was no chance mine would do this.

The reason I bought a new hot end is because I couldn't remove the throat-tube from the old hot end without it breaking, I have lots of experience disassembling old machinery, I used every trick in the book, heat, cold, freeze sprays, lubricant etc but the only way to remove it involved breaking it, drilling it out and re-tapping.
CAD-NX Printer-Raise3D N2

User avatar
Vicky@Raise3D
Posts: 6696
Joined: Fri Mar 25, 2016 3:54 am

Re: V2 hotend difficult to disassemble?

Postby Vicky@Raise3D » Mon Jun 29, 2020 11:32 pm

Would you like to share some pictures of your hotend to show the damage?

Daws
Posts: 43
Joined: Wed Dec 13, 2017 6:41 am
Location: Qld, Australia

Re: V2 hotend difficult to disassemble?

Postby Daws » Tue Jun 30, 2020 12:53 am

Hi Vicky, there is no real visible damage, my post is about the force required to disassemble the hot end.
CAD-NX Printer-Raise3D N2

Daws
Posts: 43
Joined: Wed Dec 13, 2017 6:41 am
Location: Qld, Australia

Re: V2 hotend difficult to disassemble?

Postby Daws » Mon Jul 06, 2020 1:35 am

Vicky@Raise3D wrote:Would you like to share some pictures of your hotend to show the damage?


Any thoughts as to why the hot end is difficult to disassemble? Can someone try to disassemble one at the Raise office?
CAD-NX Printer-Raise3D N2

zemlin
Posts: 512
Joined: Sat Oct 21, 2017 2:02 pm

Re: V2 hotend difficult to disassemble?

Postby zemlin » Mon Jul 06, 2020 11:15 am

I've had some that were tough to unscrew, but never to the point of damaging the throat tube.

User avatar
Vicky@Raise3D
Posts: 6696
Joined: Fri Mar 25, 2016 3:54 am

Re: V2 hotend difficult to disassemble?

Postby Vicky@Raise3D » Mon Jul 06, 2020 6:57 pm

I haven't met similar issue either.
Or any chance you can record a video to show the issue you have been experiencing with?


Return to “N Series”

Who is online

Users browsing this forum: No registered users and 2 guests