Debug why firmware won't install

Keanu
Posts: 5
Joined: Wed May 20, 2020 4:22 pm

Debug why firmware won't install

Postby Keanu » Wed Jun 10, 2020 8:09 pm

Hi all,

Does anyone know of a way to figure out what's causing the screen to not install the motion controller firmware properly? It just sticks on the flashing / please wait, or whatever it says screen. It'll install directly to the motion controller via Arduino fine, just doesn't like doing it via the screen.. Which wouldn't be an issue, but it seems that Unless you flash it through the screen, it hangs on boot and shows the whole "Boot into safe mode" via the screen thing, and expects you to re-flash it.

Just looking for some form of way to get an output from the screen to figure out what's causing this to crap itself.

Side note - it's the firmware from the Raise3D github page. Other firmwares work, just it seems a tad spasmodic to say the least.

Thanks,

Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest