N2Plus Extrusion

R4J3
Posts: 1
Joined: Tue May 02, 2017 11:17 pm

N2Plus Extrusion

Postby R4J3 » Sun Feb 09, 2020 7:36 pm

I have had my printer for almost 3 years and have had hardly any issues with it. I have been printing with no issues over the last week, printing several pieces roughly 10 hours each . Last one finished 2 days ago. Went to print a new piece today and filament will come out for about 2 to 3 inches and then will not be able to extrude any more. I am using PTEG and tried a different roll to see if that was the issue. I also changed out the nozzle to a brand new one and still have same issue. Additionally, I bypassed the gears and pressed it through manually and I have the same issue, it will start coming through and then will get stuck. I have nozzle temp set to 235. Any thoughts on what could be causing this?

User avatar
Vicky@Raise3D
Posts: 6529
Joined: Fri Mar 25, 2016 3:54 am

Re: N2Plus Extrusion

Postby Vicky@Raise3D » Tue Feb 11, 2020 12:52 am

Please check whether your cooling fans are running all time or not.


Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest