Extruder Board cable connector

jeffarazzi
Posts: 6
Joined: Tue Jun 07, 2016 11:23 pm

Extruder Board cable connector

Postby jeffarazzi » Wed Nov 13, 2019 9:16 pm

Does anyone know what the name/style of connector that attaches the 3 wires to the board on the side of the extruder is called? I was looking for a replacement connector (I've had the center wire break off a couple of times over the past couple of years and the connector is starting to look a little rough from the repairs).

I've looked at several sites that carry connectors, but can't find one that looks like the one on the N2+.

I want to have one or two on hand in case the connector doesn't survive the next repair.

Thanks.

Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest