Hello, I have an issue with the N2 Plus Dual printer. When I try to print a model, message displayed: "There is not enough available storage to print. Please delete some files in Local storage to free space" although the Local storage is completely empty.
I also found out that the built-in battery lost capacity and was swollen. Perhaps, due to an incorrect shutdown process, the printer’s internal EMMC memory has fall in read-only mode.
Attempting to lower the firmware yields nothing, the latest version 220.127.116.111 remains.
Changing the battery to fresh gives nothing too.
I have the technical ability to remove the EMMC and check it for errors and "read-only" mode.
But I noticed that mainboard has OTG jack. Maybe there is an easier way to fix this problem? In case of firmware damage, I'll can't restore it without developers help.
I hope for your technical support.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest