I have an Raise3D N2 Plus, the Z Height has always been an issue for this unit. I can level and set the bed so that Z is perfect, then start a print and it works great.
One the next print that I start the bed may be perfect, or in most cases it is too far away or too close. Each time I tell the printer to go to Z it changes slightly. I am making the assumption that this is the Z stop switch. I don't want to change it out with the same type of inaccurate switch...time for an upgrade.
I would like to change out the manual switch for an optical switch that I bought on Amazon. You can see them here:
https://smile.amazon.com/gp/product/B07 ... UTF8&psc=1
I can design an adapter bracket, but I was wondering if someone could help with wiring suggestions.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest