Pesky Problems

TheLoopyLegend
Posts: 1
Joined: Thu Aug 29, 2019 10:54 am

Pesky Problems

Postby TheLoopyLegend » Thu Aug 29, 2019 11:10 am

I've had a few problems with my device that I haven't been able to sort out so I thought I'd bring it here and get your thoughts on it

Printer: Raise 3D N2+

Problem: Extruder will happily load any filament without problem, but fails to feed filament when starting a program.

Filament types: ABS/PLA

Temperature Range: PLA 180-220c/ ABS 190-240c

Things I've Tried: I have tried swapping over the Extruder motors, replacing the heating element as well as the thermisters, I've tried cold starts and pre heating the whole printer for 1 hour. I've also pre heated the extruder and bed to correct temps so when I start the program nothing can cool down. I have even tried adding extra force too the filament to help it over come any resistance to no avail.

Other: The print fails at the very start when it pre extrudes after the machine homes, All I hear is a clicking and the extrude wheel just bounces.

ANY help at this point would be appreciated, Ask any questions you have

Return to “N Series”

Who is online

Users browsing this forum: No registered users and 2 guests