Hi there! For many months my n2 Plus had printed very well and I also used different nozzles to get really fine quality. But, a few weeks ago the prints are pretty bad.
First off all my Bondtech extruder clocked a few times, than I´ve changed the PTFE tube. No better results. I also changed the nozzles and today I switched the complete heat block....also with no better results.
I have also reset the printer to factory setting...no result.
So I´m really out of ideas what it could be. Maybe some of you could help me. I have attached an image from a typical print.
Bad prints / heavy issues
Re: Bad prints / heavy issues
This looks like not enough filament, did you change your extrusion width settings in the slicer?
CAD-NX Printer-Raise3D N2
Re: Bad prints / heavy issues
If you're having problems with your Bondtech, check to make sure the set-screw on the inside gear is tight and not causing the gear to wobble and make the filament bind. I ran into this last year and it took me a while to figure out. The symptoms jumped all over the place, just like the gear
https://forum.raise3d.com/viewtopic.php ... ech#p32520


https://forum.raise3d.com/viewtopic.php ... ech#p32520
Re: Bad prints / heavy issues
It looks like you have choosen 3 mm filament rather than 1,75 mm in the slicer. Do you use IdeaMaker? I did that mistake with cura and got something similar.
Re: Bad prints / heavy issues
I found the solution. I made a reset and forgot to change the e-steps in the settings. That was the cause.
Who is online
Users browsing this forum: No registered users and 1 guest