filament run out sensor mounting

Posts: 41
Joined: Thu Nov 30, 2017 5:29 pm

filament run out sensor mounting

Postby kencfii » Sat Dec 01, 2018 1:13 pm

Had the run out sensor for a while now and it is working fine but it will not stay firmly mounted to the machine.

I am using the new STL file Raise 3D provided and mount it with the strongest 3M mounting tape I can find. It hold for a while but then becomes loose and the sensor and mounting block tilt off the case a bit. Does not seem to cause a problem but definitely adds a bit of drag.

What is everyone else using?


Return to “N Series”

Who is online

Users browsing this forum: No registered users and 2 guests