Base layer for transition tower

Please post your suggestions for software changes here
Posts: 18
Joined: Thu Jul 13, 2017 8:32 pm

Base layer for transition tower

Postby A_Bob » Wed Mar 07, 2018 3:25 pm

Having the ability to vary the transition tower infill works great for dual extrusion as it saves quite a bit of material if using it to wipe the nozzle. One issue I have is if the infill is set low there is not much material holding the tower to the bed. It would be nice to have a solid base layer for the transition tower to help with adhesion to the bed.

Posts: 2710
Joined: Tue Mar 22, 2016 1:40 am
Location: In a van, down by the river

Re: Base layer for transition tower

Postby Jetguy » Wed Mar 07, 2018 4:44 pm

Agree on this recommendation, Mosaic had to do the same thing (solid base layer by default) for their purge tower.

As workaround until this gets implements and it is a tradeoff, using brim to aid adhesion. I know it puts it on everything, so you have it on the model too, but brim is pretty easy to just peel off with minimal defect.

User avatar
Posts: 4952
Joined: Fri Mar 25, 2016 3:54 am

Re: Base layer for transition tower

Postby Vicky@Raise3D » Thu Mar 08, 2018 7:37 am

Notes taken. We will take a look.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest