Page 1 of 1
[Feature Request] - Add top and bottom layer thickness
Posted: Mon Mar 13, 2023 4:49 pm
by mark_3d
It will be great to add this feature as mentioned in the subject, so we could have a better bottom and top surface quality, also without activating the ironing feature. For example i'm printing at a layer hight of 0,05mm and the surface are much more smooth as printing at a tickness layer.
Re: [Feature Request] - Add top and bottom layer thickness
Posted: Wed Mar 15, 2023 12:37 am
by Manuel@Raise3D
Just so I forward this feature request properly, instead of showing the layer counts for top and bottom solid fill, you'd like to see these settings displayed in thickness instead? (for example in mm instead of layer count?)
Re: [Feature Request] - Add top and bottom layer thickness
Posted: Fri Mar 17, 2023 3:54 pm
by mark_3d
Why you ask this? Indicating in mm will be better then in layer ?
Maybe it will be better to have layer split count as image below, to mantain dimensional accuracy.
For example if my mail layer thickness is 0,1mm, indicating i layer split count of 2 will divide the main layer. So i will have a surface layer thikness of 0,05mm.
But maybe with only one thinner layer it wont be enought to have a smooth surface.
Lets the developer think about that.