Page 1 of 1

[bug][Ideamaker 4.1.1.5050] Bottom Surface Solid Fill Pattern Style -> Bridge pattern

Posted: Thu May 06, 2021 2:23 am
by TheKimster
So it seems when You change the Bottom Surface Solid Fill Pattern Style, it also changes the Bridge pattern.

Re: [bug][Ideamaker 4.1.1.5050] Bottom Surface Solid Fill Pattern Style -> Bridge pattern

Posted: Fri May 07, 2021 2:30 am
by Vicky@Raise3D
The fill lines of bridging is following Solid Fill Pattern or Botton Surface Solid Fill Pattern when Bottom Surface Layer is more than 0.