Page 1 of 1

Option to Disable Esteps (M92) in Gcode

Posted: Mon Jul 13, 2020 11:19 pm
by evolwun
Would it be possible to add an option to disable the need to enter the eteps for in a printer profile? I do not need the slicer to insert an M92 EXXX line in my gcode as esteps are set in firmware. It is nice to have the option, if needed. But I don't need it, nor would anyone who has tuned there esteps via firmware.

Re: Option to Disable Esteps (M92) in Gcode

Posted: Tue Jul 14, 2020 11:54 pm
by Vicky@Raise3D
The default Estep value in printer settings should be 0. Unless you modify it to be other value, otherwise 0 Estep value won't add M92 code or affect print result.

Re: Option to Disable Esteps (M92) in Gcode

Posted: Wed Jul 15, 2020 2:19 pm
by evolwun
Thank you! This would be great to add as a tooltip when hovering over that option.

Re: Option to Disable Esteps (M92) in Gcode

Posted: Wed Jul 15, 2020 2:54 pm
by evolwun
Thank you! This would be great to add as a tooltip when hovering over that option. I could not find that info anywhere in the application.

Re: Option to Disable Esteps (M92) in Gcode

Posted: Wed Jul 15, 2020 7:39 pm
by evolwun
after setting it to "0" I get the following line in gcode:
"G92 E0.0"
Does Marlin interpret that as "use default"?

Re: Option to Disable Esteps (M92) in Gcode

Posted: Thu Jul 16, 2020 1:05 am
by Vicky@Raise3D
Would you like to share your .idea, .gcode and .data files with us so that we can test your settings on your file?

Re: Option to Disable Esteps (M92) in Gcode

Posted: Thu Aug 06, 2020 5:38 pm
by evolwun
Please disregard... I was looking at the wrong line of gcode.
sorry :oops: