Page 1 of 1

Resume at Step X of gcode

Posted: Tue Nov 12, 2019 8:22 am
by mike
as print breaks, i want to goto into recover mode. clean my nozzle, refil broken filament etc.
then i want to choose layer/step like i can do in ideamaker, and tell the printer to start at this position.
then the printer should restart priting there without destroying layers before.
so i can restart from crash without doing everything again.
also it should be possible to pause a print without moving the nozzle, just get more z axis height to clean the nozzle during a print.