Resume at Step X of gcode

Please post your suggestions for software changes here
Posts: 40
Joined: Sat Nov 09, 2019 12:24 pm

Resume at Step X of gcode

Postby mike » Tue Nov 12, 2019 8:22 am

as print breaks, i want to goto into recover mode. clean my nozzle, refil broken filament etc.
then i want to choose layer/step like i can do in ideamaker, and tell the printer to start at this position.
then the printer should restart priting there without destroying layers before.
so i can restart from crash without doing everything again.
also it should be possible to pause a print without moving the nozzle, just get more z axis height to clean the nozzle during a print.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests