Page 1 of 1

Need a ruler in ideamaker

Posted: Fri Sep 06, 2019 1:46 pm
by santro
The lack of a way to measure an object in ideamaker is very frustrating. You can scale in all direction but you have no idea what size you have scaled to
Please put a way to measure in to the software

Re: Need a ruler in ideamaker

Posted: Sun Sep 08, 2019 6:14 pm
by Jay_Omega
If you click on the object then select the 'scale' tool, it will show the x-y-z dimensions of the part.

I've found that to be pretty helpful.

Re: Need a ruler in ideamaker

Posted: Wed Sep 11, 2019 1:50 pm
by santro
Tried that but they are far from accurate, scaled up so x so size increased by 10mm printed and it was no where near it..

Re: Need a ruler in ideamaker

Posted: Thu Sep 12, 2019 7:21 pm
by Vicky@Raise3D
Would you like to advise more information about the inaccurate issue you meet? The measurement is not accurate or the print result is not good enough for you?
If any picture available to explain the problem you are facing with, it will help a lot.