Interleaving layers with dual material

Please post your suggestions for software changes here
seattleprinting
Posts: 5
Joined: Thu Apr 18, 2019 10:30 pm

Interleaving layers with dual material

Postby seattleprinting » Thu May 16, 2019 10:12 pm

I was using a wipe wall with sparkle black and silk blue filaments. Since the wipe wall interleaves the two colors (switches colors every layer), it left a very beautiful deep blue sparkly shell around the object. I was jealous that my model wasn't that same color 8-) I started searching for a setting that would interleave the model itself in the same manner but came up empty.

Any interest in a setting like that? It would basically turn on the wipe wall or tower and alternate between the two extruders each layer.

Neil

User avatar
Vicky@Raise3D
Posts: 5463
Joined: Fri Mar 25, 2016 3:54 am

Re: Interleaving layers with dual material

Postby Vicky@Raise3D » Fri May 17, 2019 5:27 pm

Do you mean print a model out with different nozzles for each layer alternately?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests