Different infill per model in multi model prints

Please post your suggestions for software changes here
ppurdy
Posts: 3
Joined: Fri Feb 22, 2019 3:59 pm

Different infill per model in multi model prints

Postby ppurdy » Fri Feb 22, 2019 4:42 pm

I would like to use a different infill setting when I am printing multiple models overnight, this could save me a lot of time as I print small models during the night and some of the models don't need much infill because I will be making silicon moulds for duplicating but some are structural and need more infill..

It's a pain printing all the models with the higher infill settings and then not being able to get all the prints finished overnight.

User avatar
Vicky@Raise3D
Posts: 5463
Joined: Fri Mar 25, 2016 3:54 am

Re: Different infill per model in multi model prints

Postby Vicky@Raise3D » Fri Feb 22, 2019 10:19 pm

You can achieve it with Per-group setting, if the models are individual with each other.
1.jpg


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests