I would like to use a different infill setting when I am printing multiple models overnight, this could save me a lot of time as I print small models during the night and some of the models don't need much infill because I will be making silicon moulds for duplicating but some are structural and need more infill..
It's a pain printing all the models with the higher infill settings and then not being able to get all the prints finished overnight.
Please post your suggestions for software changes here
2 posts • Page 1 of 1
You can achieve it with Per-group setting, if the models are individual with each other.
Who is online
Users browsing this forum: No registered users and 2 guests