Page 1 of 1

Live change infill/support

Posted: Mon Sep 03, 2018 2:04 pm
by simon_srp
Hi

I would find it nice to be able to change infill/support settings when my feature is in sliced preview mode. Then I would be able to see the differences in the construction/design/time elapse and amount om material directly when I choose between all the different support types or infill types.

Because now I first have to close the slice preview, then change my settings and then slice it again and then repeat it until im satisfied.
I think it can be smoother and easier and much more time efficient if I simply can choose another option and see the effect directly.

Re: Live change infill/support

Posted: Tue Sep 04, 2018 6:50 pm
by Vicky@Raise3D
You should can directly carry out another slicing from the preview page if you are running the latest version of ideaMaker.
1.png

Re: Live change infill/support

Posted: Tue Sep 04, 2018 8:29 pm
by Korni
However, we CAN NOT directly view or change any changes in the preview page, but MUST first to slice back.
simon_srp is right

Re: Live change infill/support

Posted: Thu Sep 13, 2018 11:57 am
by simon_srp
Korni wrote:However, we CAN NOT directly view or change any changes in the preview page, but MUST first to slice back.
simon_srp is right



Yes, exactly.
I would like to change the infill type direct in slice-mode, so I instantly can compare the printing time and/or build design etc.

Re: Live change infill/support

Posted: Wed Sep 19, 2018 5:42 pm
by KS_Husker
I agree. I noticed this recently after using a different software before. I miss the quick view change option to quickly see what the effect will be.